how to change default printer on surface pro 3

#How to change default printer on surface pro 3 how to

Replacement sensor stem for the BLTouchīelow you'll find links to each product you'll need if you're buying pieces separately.Mounting bracket (for Ender 3 V2, Ender 3, and Ender 3 Pro).If using the BLTouch kitĪgain, it has everything you need to install the BLTouch on the Ender 3 V2, original Ender 3, or Ender 3 Pro. A note on the product usedĪs stated above, we highly recommend you save yourself some hassle and go with the BLTouch kit we used for the install. Ready to get started? Skip ahead to begin your BLTouch setup. That's where we come in! In this guide, we'll walk you through the process of installing and setting up your BLTouch auto-bed leveling sensor on your Ender 3-series printer, as well as anticipate any issues that may arise for you.

#How to change default printer on surface pro 3 how to

(What serious upgrade for the Ender 3 isn't?!) Because the V2 is so new, there's very little information available on how to properly set up the BLTouch on the Ender 3 V2, and what is available is often so slight that it really wasn't helpful at all.

Still, we found the process to be not-so-straightforward and a bit frustrating at times. But we'll also show you how to set up the BLTouch on the Ender 3 and Ender 3 Pro. Setting up and installing the BLTouch on the Ender 3 V2 is made easier due to the ability to flash firmware onto the Ender 3 V2 via an SD card and the added support that Creality gives to the BLTouch now. While we use an Ender 3 V2 to write this BLTouch guide, we note the different steps for the original Ender 3 and Ender 3 Pro. Remember the days when you found yourself hunkered down over your Ender 3, Ender 3 V2, or Ender 3 Pro with a sheet of paper in your hand, literally spinning your wheels? Was that yesterday? Well, with a BLTouch installed, it doesn't have to be tomorrow! Forget about leveling your Ender 3 bed or adjusting a Z-offset ever again.